Home & Garden: Page 16

With this video, we learn how to recycle milk bottles to make decorative flowers. First, mark eight coupled marks on four sides of the bottom of the bottom. Then, poke holes into them and cut into them with sharp scissors. From here, you will continue to do this all the way around the bottom of the bottle until you have created petals. Then, cut above these to make long oval types of shapes and then spread the petals out on the bottom and on the top. Pull the longer petals into the open areas...

Glue is one of the worst things that you can get on your clothes. It sticks to most things and fabric is no exception. Watch this video to learn how to get glue stains out of any type of clothing.

In this video, we learn how to strop on a stropping block. There are two layers to the strop and they measure different lengths. On the bottom you should put two mouse pads to make sure it stays put. Now, charge the strop with a stropping compound and rubbing it against the grain until it flakes off. Next, gauge the angle of your knife and place the blade against the strop. Push against the edge of the blade and work from the top to the bottom in a long and slow arch. This is all there is to...

In this tutorial, we learn how to kill a cockroach kindly. If you currently use insecticides to kill bugs and insects in your home, rethink it! These fumes can be toxic to your health and the health of your family. To help avoid getting cockroaches, make sure you dust and sweep often, throw away food around the house, and keep it clean! If you do have these bugs, you can first pour some beer in a glass, then put bread in the glass along with some petroleum jelly. Next, you will set this on...

Skunks are cute little animals with a nasty surprise waiting in the gland under their tail for anything that threatens them. If you've been sprayed by a skunk, you're never going to be at peace until your get rid of that smell, and this video will teach you how to do just that.

Moss can be a beautiful part of natures, but it can also wreak havoc on your roof shingles or garden plants and rocks. If you've got a moss problem, watch this video for some easy ways you can solve them.

You're trying to mow your lawn, but the engine on your pull-string push mower isn't turning over— why won't it power up? Well, if your lawn mower was stored outdoors for a large amount of time, chances are that the recoil has built up some corrosion or is simply sticking. This video will show you a very simple repair, where you only need to remove 2 or 3 screws to gain access to the mechanism, then grease with silicone spray.

The garbage disposal is one of the handiest modern appliances because they can grind up anything and send it down the drain. Or can they? Watch this video to learn what you can and can't put down your garbage disposal if you don't want it to clog.

Is your silverware or silver jewelry showing too much tarnish? You can remove the tarnish easily by using a baking soda toothpaste. This tutorial demonstrates how you can use just a dab of toothpaste, a soft cloth and some rinse water.

Dumpsters make great swimming pools and skateboard ramps, but when they're full of trash, they're pretty valuable, too. You can get a surprising amount of free booty dumpster diving. If you're a penny pincher who values low cost (re: free) functionality, check out Apartment Therapy's guide to mastering the craft. Below, my three favorite insider tips.

In this video we learn how to install a toilet water inlet valve. First, turn the water off and flush the toilet to get rid of the water in the system. From here, pull out the flush valve by turning it clockwise and lifting it. Then, grab your new valve and replace it where the old one was. Clean around the area and replace any other parts that you need to inside the tank. Once finished, you can turn the water back on. Now try to flush your toilet to make sure that it works. It should be good...

In this tutorial, we learn how to build plumb walls. A plumb bob is a weight that you can use to make sure your walls are plumb. This tool is the most accurate tool you can get to plumb up any wall. Your level is only good until it's dropped, this won't be ruined and will always be accurate. When using a plumb bob, you have to get up close and personal to the floor and the ceiling. You will need someone on the floor and someone on the ladder to make sure you get the bob exactly on the line....

In this video, we learn how to install a locking hardwood floor with Lowe's. First, prepare the sub floor before you begin installing the floors. After this, grab all of the tools you need to install the flooring properly. Place spacers between the flooring and the walls and start to lay it down. Lock the planks together on the first row. Then, lock the sides to the next row and use weights to keep the floors from moving. The ends must be 6 inches apart on each row. For a locking floor, cut off...

In this tutorial, we learn how to get rid of that smell coming from your shower with Bob Schmidt. First, you will want to clean out your drain pipes to make sure the smell is not coming from there. If the smell is coming back out, you will need to do additional work. If water gets saturated into the base of the shower, then there should be some gravel around it so the water can soak through and go down into the drain pipe. If moisture soaks through the tile grout, then it can bring out the...

In this video we learn how to replace an electrical light switch. First, turn the power off in your home. Then, remove the screws around the switch exposing the wires. Confirm that they are dead with a tester, then you can get started removing. Wrap electrical tape around the wires and then label them with what they were connected to. Tear this out of the terminals, then replace the new one with the wires hanging out. Make sure you place the wires back into the same terminals as before, using...

This is a video tutorial in the Home & Garden category where you are going to learn how to make a sign using a wood router free hand. For this you will need a router. The kind of router you use is not so very important. But, what is important is the router bit. It should be a "V" shaped bit for doing free hand work. There are lots of bits you can use. First you fix the depth of the cutter so that only a little bit of the router bit is exposed. You should not be seeing too much of the bit above...

In this video, we learn how to cut plastic push-fit pipe. Make sure you never use a hack saw to cut the push-fit pipe because it can damage the O-ring in the connector. What you need is a pair of dedicated plastic pipe cutters. Once you have this, put your pipe in the middle of the cutters and then push down on the handles. After this, your will cut the pipe and it will com out nice and clean. From here you will be able to fit a connector into the pipe and continue to use it rather than ruining...

In this tutorial, we learn how to solder copper water lines. First, take a sand cloth and thoroughly clean the outside of the tube. Then, take a cleaning brush and clean the inside cup of each side of the fitting. Apply flux to the inside of the fitting, then insert the tube inside. Make sure the tube is inserted into the bottom of the cup properly. Now, take a torch and apply the head to the cup of the fitting. Wait until the solder starts rolling and goes all the way around the fitting. When...

In this video, we learn how to change your toilet into a silent toilet seat. A silent toilet seat will shut itself by going down slowly without the loud slam. To remove the old toilet seat, go to the back flaps and pop them up. Remove the plastic screws with a screwdriver and then set them aside. Replace this with your new toilet seat and screw the screws back into the back. Now, lift your seat and the lid up and tap them gently. After this, the toilet seat will slowly start to lower and close...

In this video we learn how to makeover your mirror with accessories. First, grab lace, string, ribbon, fake flowers, and anything else decorative that you want to hang around on your mirror. Once you have all of your supplies, get to work! Use double sided tape to stick to the sides of the mirror so you can safely stick on all of your accessories. Start out by taping some lace or ribbon around the mirror. You can also tie some ribbons and place those as on as well. If you have fake flowers,...